Knuckle Cracker Wiki

User Tools

Site Tools

Trace:
4rpl:commands:createbeam

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
4rpl:commands:createbeam [2022/05/25 22:23] – [Description] Continuous beams in motion. Vertu4rpl:commands:createbeam [2025/02/14 14:57] (current) – external edit 127.0.0.1
Line 19: Line 19:
   * 'width' is a float ranging from 0 up. The width is the thickness of the beam. Beams are flat geometry so keep the beam width relatively small (1-10 typically).   * 'width' is a float ranging from 0 up. The width is the thickness of the beam. Beams are flat geometry so keep the beam width relatively small (1-10 typically).
  
-**Important note:** If you are planning to create a continuous beam on a unit that will be moving while firing, do not attach the beam to the unit. An attached beam will be unable to maintain the correct visual orientation and length. An unattached beam so long as its' start location is updated will retain a correct visual orientation.+**<fs medium>__Important note:__</fs>** If you are planning to create a continuous beam on a unit that will be moving while firing or the end of the beam is meant to track something that moves, do not attach the beam to the unit. An attached beam will be unable to maintain the correct visual orientation and length in such situations. An unattached beam so long as its' start and end location is updated will retain a correct and accurate visual orientation and will give much better results.\\ 
 +Attached beams are best for simple units such as a unit that fires a beam at Creeper. The targeted Creeper location does not move and if the unit does not move while the beam is visible than it is safe to attach the beam to the unit and no unwanted visual errors will occur. 
 + 
 +:NOTE: Beams become invisible at long distances when they are a size lower than 0.5 so if you want the beam to always be visible, keep the width at a minimum of 0.5. The smaller the beam, the closer the camera must be for it to be visible.\\ 
 +This can also be useful when using a large number of beams such as targeting lasers to ensure the player's screen is not flooded with beams when zoomed out. If you want a beam to be moderately visible, 0.35 is a great width.
 ===== Examples ===== ===== Examples =====
 <code 4rpl> <code 4rpl>
4rpl/commands/createbeam.1653517391.txt.gz · Last modified: 2025/02/14 14:56 (external edit)

Page Tools

Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
CC Attribution-Share Alike 4.0 International Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki