Knuckle Cracker Wiki

User Tools

Site Tools

Trace: • ceil • setunittargetoffset • setobjrotation • isbeam
4rpl:commands:rplcamtween

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
4rpl:commands:rplcamtween [2024/07/01 19:38] – Bug note Vertu4rpl:commands:rplcamtween [2025/02/14 14:57] (current) – external edit 127.0.0.1
Line 8: Line 8:
 Causes the camera, in rpl mode, to move to pos and rotate to rot (both vector3s) over the specified time in seconds. Causes the camera, in rpl mode, to move to pos and rotate to rot (both vector3s) over the specified time in seconds.
  
-:WARNING: Should you be using multiple of these API in succession: be weary that when the elapsed time completes for any use of this API, it will have the camera switch to it. In other words, if you run this API for one case that takes 6 seconds but then run another that takes 4 seconds less than 2 seconds after the first use of the API, the camera will transition to the 2nd use of the API but once the time would of expired for the first use of the API, the camera will proceed to snap into the placement of the 1st use of this API.+:WARNING: If you use this again while it's still active, it keeps track of any movements that are still running, so if you start a long movement and then do a short movement, after the short movement finishes it will return to the long movement if that still had time remaining and hadn't yet reached its destination. (I.e. if you start a eight second movement, and then start a two second movement two seconds in, at the four second mark it will return to where it would have been four seconds into the eight second movement.) 
 + 
 +One way to avoid this issue is to avoid overlap by calling interruptions too early and only interrupt things at the end of the movement, or at least close enough the duration doesn't last beyond the new movement.  
  
 ===== Examples ===== ===== Examples =====
Line 15: Line 17:
 </code> </code>
 <code 4rpl> <code 4rpl>
-GetCameraPosition ->cameraPos +RPLCamCopyPosAndRot #So when RPLCam is activated, we say the current camera is how the RPL cam should start as.
-GetCameraRotation ->cameraRot +
 SetRPLCam(true) SetRPLCam(true)
-SetRPLCamPosition(<-cameraPos) #So the camera isn't sitting at 0,0,0. +RPLCamTween(V3(40 20 30) V3(40 0 0) 1.5) #Have the RPLCam move to this position and rotate to this rotation.
-SetRPLCamRotation(<-cameraRot) #So the camera isn't oriented as 0,0,0. +
- +
-RPLCamTween(V3(40 20 30) V3(40 0 0) 1.5)+
 </code> </code>
 <=[[4rpl:start| Index]] <=[[4rpl:start| Index]]
  
4rpl/commands/rplcamtween.1719862719.txt.gz · Last modified: 2025/02/14 14:56 (external edit)

Page Tools

Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
CC Attribution-Share Alike 4.0 International Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki